Obsessed Garage Logo Shirt Subtype - Hoses Inlet = 1/4" (National Pipe

Inlet = 1/4" (National Pipe Thread) NPT Male:  This 1/4" male threaded end screws into a female 1/4" connection

I still blow-dry the car

I decided not to include the Hardware Hider Caps

I also did a section of the Raptor with Nano Resin Pro that looked and was applied much like ISM

these are still the typical 20-gauge baked White Enamel Steel

Obsessed Garage Logo Shirt Subtype - Hoses Inlet = 1/4" (National PipeThe Obsessed Garage Logo shirts are our most purchased and iconic shirts, if you visit our location you'll probably see at least half of our employees sporting a basic shirt! We wanted a minimal but high quality shirt, we use embroidery and a high quality water based printing process whenever possible from our local screen printer Hittn' Skins. We print almost all our merchandise on Los Angeles Apparel. Next Level, Canvas, Gildan, etc. aren't cut the